6Ch Linear Vibration Motor Auto-Tester Type BK8017
Configuration
BF1020 with 6 X BK8017 DAQ
PC with BS1123 "Test Shop" SW
6 X Custom Couplers
Auto-Loading System
The Linear Vibration Motor Autotester:
If you are putting out thousands of linear vibration motors
every day, the BK8017 might be just what you need for high
quality product line testing. Based on the popular
BK2120C Linear Vibration Motor Tester,
you can run up to four vibration sweeps that you define and
the results are analyzed by the software. DUT's are then
automatically sorted into the appropriate bin. The whole
process, equivalent to 3 BK2120C machines, takes just a
few seconds and can be run by one person.
If you'd like more information about our Linear Vibration Motor Testers, contact me at this address.
If you'd like more information about our Linear Vibration Motor Testers, contact me at this address.
NEXT
Specifications:
General:
Input Channel: 2 Independent Ch
Display: Ext. Display
Input Channel:
Input Mode: Voltage, ICP
Input Range: 10mV to 10V 10dB Step
Input Impedance: 100kΩ
Input Ground: Single Ended
Max. Input Voltage: 40Vp-p
Connector Type: BNC
Frequency Response: 20Hz to 22kHz at 0.1dB
Channel Amplitude Mismatch: Max. 0.1dB
Overload Detection: Yes
Dynamic Range: > 96dB
Auto Range: Yes
Signal Monitoring: Yes (Option)
Sensor Interface: ICP Type Microphone or Accelerometers
Sampling Frequency: Max. 48kHz (each Channel),(96kHz Option)
ADC: 16bit (24Bit Option)
Frequency Range: 20 Hz – 20kHz
Generator & Power Amplifier:
Signal Mode:
Fixed Sine 10 Hz to 20kHz
Sweep Sine 10 to 20kHz
Signal Level: 1mV to 1V rms
Amplitude Error: 0.1dB 20Hz - 20kHz
Power Amplifyer
Max. Power: 10W at 8Ω
Load: >4Ω
THD: 0.03% at 1kHz
NEXT
ICP Power (Microphone Power):
Power Voltage: 24V
Driving Current: 4mÅ
Analysis Mode:
FRF Mode
Sweep Sine
Linear Step, 20Hz to 20kHz
T.H.D.: 0.01% to 99% ( 20Hz to 10kHz)
Impedance: 1 to 100ohm (20Hz to 20kHz)
Raw Data Recording: Wav Format
Calibration:
Auto Input/Output Sensitivity Calibration: Yes
Interface:
OK/NG Display Box
Foot Switch for Handsfree Start
Power:
AC 90 - 220V, 50/60Hz
Max. 3Å
Dimensions:
Hardware: 330 x 72 x 275 (W,H,D)